Procurement Technical Assistance Centers (PTACs) are an official government contracting resource for small businesses. Find your local PTAC (opens in new window) for free government expertise related to contract opportunities.

Greetings!

We require a 6’ x 8’ security booth with lifting slots for a forklift that will serve as our quarterdeck booth for our cutter. We will review all quotes that are submitted and make our choice based on lowest bid price. Once we determine the lowest bid, we will reach out to the awarded vendor via email and to all vendors that submitted quotes with the final decision. This solicitation is time sensitive, so please submit an accurate quote with your final offer. Contract specialist will not attempt to negotiate for a better price or lead time and will evaluate all quotes at face value. Vendor must be registered and active in SAM.gov. We request that interested vendors provide 2 separte quotes; 1 for Net 30, purchase order, payment terms and 1 for credit card payment terms. This product is to be delivered to 1001 S. Seaside Ave. San Pedro, Ca 90731. Please let me know if you have any clarifying questions and I will answer them in an expeditious manner. See below for specifications:

• 
  

  Unit to be designed for exterior use and constructed of minimum

  
  
  

  2” x 2" x .083” structural steel tube frames with R-10 insulated, 16ga galvanized steel interior and exterior walls, with an additional layer of continuous exterior R-9.6 insulation encapsulated in the final exterior layer of 16ga. galvanized steel panels. Overall rating for the wall insulation is R-19.6.

  
  
  

  Roof to be insulated to R-19 and constructed of internal steel framing with 16ga. galvanized steel decking welded to the framing and then coated with a three part membrane with a solar reflective index of 95 or greater. Roof will have a 10” fascia and 6” overhang on all sides. Roof to drain to rear downspouts.

  
  
  

  12ga. Galvanized steel plate floor covered with black polyvinyl chloride commercial black resilient textured 20” x 20” inter locking tiles and 4" high black base cove, floor system is welded to a 3" galvanized steel tube frame and joists.

  
  
  

  One commercial steel framed sliding door top hung by a minimum of eight 2 1\4” rigid steel ball bearing rollers with a lower stainless steel guide, stainless steel handles welded to the frame and mortise lock.

  
  
  

  Fixed windows on all sides glazed with 3/4" clear tempered dual pane insulating glass with Low-E coating.

  
  
  

  Interior 1’ x 4’ LED light recessed in a galvanized steel ceiling painted the match the booth and mounted at 90” AFF. Light is controlled by dimmer switch.

  
  
  

  One interior 6” diameter LED down light with red shielding for task lighting, light is controlled by a wall mounted dimmer switch.

  
  
  

  Prewired 120/240 volt 12 pole 125 amp rated single phase load center wired to a exterior weather tight shore power plug. Three duplex outlets mounted under a 20” deep full width type 304 stainless steel work counter.

  
  
  

  One exterior weather tight 6” x 6” J-Box with a 1 1\2” conduit through the wall to a 6” x 6” interior J-Box.

  
  
  

  Commercial through the rear wall mounted HVAC with 12,000 BTU cooling and 11,200 BTU electric heating and a 230 volt dedicated outlet. 1500 watt fan forced wall mounted auxiliary heater with integral thermostat.

  
  
  

  Booth will be painted one color of customers choice using high solids polyurethane paint over two part polyurethane primer

  
  


• 
  

  Provide welded in place C-Channel forklift pockets in the floor frame